Evaporator Assembly And Filter-Drier - Sub-Zero Wine Storage 315W Technical Service And Parts Manual

Wine Storage

Evaporator Assembly and Filter-Drier

The evaporator assembly consists of the evaporator
and heat exchanger. The evaporator is mounted to the
inside rear wall of unit. The heat exchanger is routed
out the back wall, down to the unit tray where the capil-
lary tube is connected to the high-side filter-drier and
the suction tube is attached to the compressor suction
port.
To remove an evaporator assembly (See Figures 5-13,
5-14, 5-15):
1. Evacuating refrigerant from sealed system.
2. From back of the unit use a tin snips or similar tool
to cut heat exchanger as close to back wall as pos-
sible.
3. Extract screws securing evaporator to rear wall of
refrigerated compartment, then pull evaporator from
compartment.
4. With a tube-cutter, cut filter-drier from condenser
outlet, and suction tube from compressor.
NOTE: After new evaporator assembly is installed,
the tubing channel must be sealed shut with sili-
cone.
Model 315W
5-9
Component Access / Removal
Figure 5-13. Cut Heat Exchanger
Evaporator
Extract
Screws
Figure 5-14. Evaporator Removal
Condenser
Figure 5-15. Cut Drier Inlet & Outlet
#3758664 - First Edition - July, 2005
Cut Here
Filter-Drier