Network Connection & Ip Assignment - Vicon SN680D-WNIR Quick Manual

2.4 Network Connection & IP assignment
The network camera is designed for use on an Ethernet network and requires an IP address for
access. Most networks today have a DHCP server that automatically assigns IP addresses to
connected devices. By the factory default, your camera is set to obtain the IP address
automatically via DHCP server. If your network does not have a DHCP server the network
camera will use 192.168.1.100 as the default IP address.
If DHCP is enabled and the product cannot be accessed, run the "SmartManager" utility on the
CD to search and allocate an IP address, or reset the product to the factory default settings and
then perform the installation again
1) Connect the network camera/device to the network and power up.
2) Start SmartManager utility (Start > All programs > SmartManager > SmartManager). The
main window will display, and after a short while any network devices connected to the
network will be displayed in the list.
3) Select the camera on the list and click right button of the mouse. The pop-up menu displays
as below.
4) Select Assign IP Address. The Assign IP window will display. Enter the required IP address.
SN680D-WNIR Quick Installation Guide
Note: For more information, refer to the SmartManager
User's Manual.