For Grandstream Handytone 486(487), 286(287), Ata - Grandstream Networks GXP 280 Configuration Manual

20. Set 'Enable Call Features' to 'Yes'. This setting enables feature like transfer, on
hold etc from the analog phone connected to the FXS port of the device.
21. Set the 'Preferred Vocoder' to choice 1: PCMU, choice 2: PCMA. The settings for
choices 3 to 6 will not come in use since they will not be used by MyPBX.
22. Set 'Allow outgoing call without Registration' to 'yes'.
23. Scroll to the bottom of the page and click the 'Update' button. You will be
prompted to reboot the device. Click the 'Reboot' button.
24. Repeat steps 11-24 for the configuring 'FXS port 2'.
25. After the HandyTone has restarted, switch to MyPBX Management Console, and
click on 'Line Status', your new extension connected to the PBX should be listed
with a blue status light.
For GrandStream
486(487), 286(287), ATA
Configuring GrandStream HandyTone 486(487), 286(287), ATA for
MyPBX
Important
This guide has been tested with firmware version 1.1.0.37. Be aware that different
firmware revisions may have different web interface formats and functionality. This
is based on a new ATA OR one that has been reset to factory defaults.
www.yeastar.com
Grandstream IP Phone Configuration Guides
HandyTone
Page 7