Zodiac V1 Owner's Manual
  1. Manuals
  2. Brands
  3. Zodiac Manuals
  4. Swimming Pool Vacuum
  5. V1
  6. Owner's manual

Zodiac V1 Owner's Manual

Hide thumbs Also See for V1:
Table of Contents

Advertisement

Quick Links

TM
Owner's Manual
WARNING
FOR YOUR SAFETY - For anything other than the routine cleaning and maintenance described
in this manual, this product must be serviced by a contractor who is licensed and qualified in pool
equipment by the jurisdiction in which the product will be installed where such state or local
requirements exist. In the event no such state or local requirement exists, the maintainer must be
a professional with sufficient experience in pool equipment installation and maintenance so that all
of the instructions in this manual can be followed exactly. Improper installation and/or operation will
void the warranty.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the V1 and is the answer not in the manual?

Questions and answers

Related Manuals for Zodiac V1

Summary of Contents for Zodiac V1

  • Page 1 Owner's Manual WARNING FOR YOUR SAFETY - For anything other than the routine cleaning and maintenance described in this manual, this product must be serviced by a contractor who is licensed and qualified in pool equipment by the jurisdiction in which the product will be installed where such state or local requirements exist.

  • Page 2: Table Of Contents

    If the original dealer does not perform warranty service, please visit www.zodiac.com.au to locate an independent service company near you. If you are unable to locate a service company, please call our Technical Support Department on 1800 688 552.

  • Page 3: Important Safety Instructions

    • Do not bury cord. Locate cord so as to prevent it from being damaged by lawn mowers, hedge trimmers and other equipment. • To reduce the risk of electrical shock, do not use the Zodiac V1 robotic cleaner or control unit if the cord is worn or damaged. Contact Zodiac Group Australia. technical support immediately for a replacement cord.
  • Page 4 Ink from the pattern can also rub off during the installation process or when it comes into contact with objects in the pool. Zodiac Group Australia, is not responsible for, and the Limited Warranty does not cover, pattern removal, abrasion or markings on vinyl liners.

  • Page 5: Zodiac V1 Specifications

    Therefore, devices having double-insulated construction, such as the Zodiac V1, do not utilize a Using the appropriate drill bit, drill three (3) holes. grounded (three-prong) cord/plug.

  • Page 6: Electrical Connection

    RCD. • Do not use an extension cord to connect the control unit. • Do not allow anyone to swim while the Zodiac V1 robotic cleaner is in the pool. For your safety and to obtain the best possible Figure 4.

  • Page 7: Removing The Cleaner From Pool

    • Do not leave your cleaner in the pool on a permanent basis. Never lift the Zodiac V1 out of the pool by the • At the end of each cycle, remove the cleaner from floating cable. Always use the handle to remove the pool.

  • Page 8: Cleaning And Maintenance

    Page 8 Section 5. cleaning and Maintenance WARNING To avoid electric shock and other hazards which could result in permanent injury or death, disconnect (unplug) the cleaner from the electrical outlet before performing any cleaning and maintenance. 5.1 cleaning the Filter canister The filter canister should be cleaned at the end of each cycle.

  • Page 9: Cleaning And Storing The Cleaner

    Page 9 Front Clip Figure 13. Position and lock the Filter canister in Place Figure 15. Push Brush Arm Brush Shaft Brush Bushing Figure 14. Install the cover Figure 16. Remove and Replace the Brush From 5.3 cleaning and Storing the cleaner the cleaner The cleaner must be cleaned regularly using slightly soapy clean water, do not use solvents.

  • Page 10: Replacing The Tyres On The Cleaner

    Page 10 5.5 Replacing the Tyres on the cleaner Using your fingers, pull on the inside of the old tyre to remove the tyre lip from the wheel. See Figure 17. Figure 19. Tyre Replacement Orientation Push one side of the tyre on to the wheel and fit the tyre onto the wheel as shown in Figure 20.

  • Page 11: Troubleshooting

    Make a visual check of the impeller. If the impeller is clogged, unplug the damaged. main power cord from electrical receptacle then, remove debris. If the impeller is damaged contact your local Zodiac service representative. The cleaner There is air in the Submerge the cleaner following the procedure in Section 4.1,...
  • Page 12 Zodiac Group Australia Pty Ltd (Zodiac Australia) warrants that the Zodiac possible after purchase by completing a Product Warranty Registration V1 robotic cleaner will be free from defects in materials and workmanship Form and posting it to Zodiac Australia at the address shown on the for the period of 2 years from date of purchase.

Table of Contents