Troubleshooting; Blown Fuse Or Circuit Breaker; Slushy Ice. Water In Hopper; Beverages Do Not Dispense - Cornelius remcor DB275--BCP Operator's Manual

Ice/beverage dispenser
Table of Contents

Advertisement

IMPORTANT: Only qualified personnel should service internal components or electrical wiring.
WARNING: If repairs are to be made to a product system, remove quick disconnects from
the applicable product tank, then relieve the system pressure before proceeding. If repairs
are to be made to the CO
system pressure before proceeding. If repairs are to be made to the refrigeration system, make sure
electrical power is disconnected from the unit.
Trouble
NOTE:
should your unit fail to operate properly, check that there is power to the unit and that the
hopper contains ice. If the unit does not dispense, check the following chart under the
appropriate symptoms(s) to aid in locating the defect.
BLOWN FUSE OR CIRCUIT
BREAKER.
BREAKER.
SLUSHY ICE. WATER IN
SLUSHY ICE. WATER IN
HOPPER
HOPPER
BEVERAGES DO NOT
DISPENSE.
DISPENSE.
BEVERAGES TOO SWEET.
BEVERAGES TOO SWEET.
BEVERAGES NOT SWEET
BEVERAGES NOT SWEET
ENOUGH.
ENOUGH.
BEVERAGES NOT COLD
(UNITS WITH BUILD-IN COLD
PLATE).
NOTE: Contact your local syrup or beverage equipment distributor for additional information and
trouble shooting of beverage system.
620906904

TROUBLESHOOTING

system, stop dispensing, shut off the CO
2
Probable Cause
A.
Short circuit in wiring (115V
circuit).
B.
Defective agitator motor.
A.
Blocked drain.
B.
Unit not level.
C.
Poor ice quality due to water
quality or ice maker problems.
D.
Improper use of flaked ice.
A.
No 24 volt power to faucets.
B.
No CO
pressure.
2
A.
Carbonator not working.
B.
No CO
pressure in
2
carbonator.
C.
Faucet brix requires adjusting.
A.
Empty syrup tank.
B.
Faucet Brix requires adjusting.
A.
Unit standing with no ice in
hopper - no ice in cold plate
cabinet.
12
supply, then relieve the
2
Remedy
A.
Replace defective wiring.
B.
Replace agitator motor.
A.
Open--up/flush out drain.
B.
Level unit.
C.
Install water filter system. For
Icemaker problems, consult
icemaker manual.
D.
Replaced flaked ice with " cube
style ice (see page2, Unit
Description).
A.
Check that beverage switch is
" on" . Check 24V transformers.
B.
Check CO
regulator. Check CO
2
tank pressure.
A.
Check carbonator.
B.
Check CO
regulator. Check CO
2
tank pressure.
C.
Brix Faucet.
A.
Refill syrup tank.
B.
Brix Faucet.
A.
Refill hopper with ice.
2
2

Advertisement

Table of Contents
loading

Table of Contents