After loading a send effect and setting its return level, set the level the Track sends to it:
1.
Enter Track Mixer Mode by pressing Shift + Prog Mix / Track Mix.
2.
Press F4 (Send) to view the channels' send effect levels. (To show another set of 16 channels,
select the Track field in the upper-right corner and use the Data Dial or the -/+ buttons. You can
repeatedly press F4 (Send) to cycle through the four available insert effect slots. The small squares
below the tab indicate the currently selected slot.)
3.
Use the Q-Link Knobs to adjust the send level of the corresponding channels. Alternatively, use the
Cursor Buttons to select the desired channel and use the Data Dial or -/+ buttons to set the level.
4.
Use the Data Dial or -/+ buttons to set the return effect level.
Master Effects
To load and edit a Master insert effect:
1.
In the software, click the Track Mixer tab in the Mode Tab Section.
2.
In the Master FX section in the lower-right corner of the window, click the
downward arrow ( ) of the drop-down menu of the slot you want to assign an
effect to. Select an effect from the window that appears.
Click a loaded effect name to open its graphic user interface to edit its parameters.
Hardware:
To load a master insert effect:
1.
Press Shift + Seq Edit / Effects.
2.
Press F5 (Insert).
3.
Use the Cursor Buttons to navigate to the desired Insert effect slot.
4.
Use the Data Dial or the -/+ buttons to open another page to select an effect. Click F4 (Select) to
load it, or click F3 (Back) to close the page.
177