Controller Mod Section (Keygroup Program Only) - Akai MPC User Manual

The LFO modulation Destinations determine the amount of effect of the LFO has on Pitch, Filter Cutoff
frequency (Filter), Volume (Amp) and Panning (Pan).
Hardware: To edit the LFO parameters, press the F5 button (Lfo Mod). For Drum Programs, use Q-Link
Knobs Q1 – Q7 for direct access to all seven parameters. For Keygroup Programs, use Q-Link Knobs
Q5 – Q12 for direct access to all seven parameters. (Remember that a Drum Program uses different
controls than a Keygroup Program.)

Controller Mod Section (Keygroup Program Only)

This section determines the influence of additional play controllers on
various sound parameters.
Important: To use these parameters, make sure that a connected MIDI
device can send pitch bend messages as well as aftertouch and
modulation wheel data.
Pitch Bend sets the range (in semitones) of a connected MIDI keyboard's pitch-bend wheel.
Whl>LFO (Wheel to LFO) determines how much a connected MIDI keyboard's modulation wheel affects
the LFO intensity.
Aft>Filt (Aftertouch to Filter Cutoff) determines how much a connected MIDI keyboard's aftertouch data
affects the filter cutoff.
Hardware: To edit the Controller Mod parameters, press the F5 button (Lfo Mod). Use Q-Link Knobs
Q2 – Q4 for direct access of all three parameters. Remember that these parameters are available only in
Keygroup Programs.
106