Trouble Shooting - Wintec WPL-2000 User Manual

TrOUBLE SHOOTiNG

If you run into any problem using WPL-2000, use the following table to troubleshoot the
problem. If the problem persists, contact your dealer for further service.
The WPL-2000 can not get acquisition.
Ð Ð
You may be in a location where the radio signals from GPS satellites can not be reached.
Ð
Avoid using the unit in the locations such as tunnels, underground locations or among
Ð
obstructions such as tall buildings or thick forest.
The sun shade in the vehicle may effect the reception.
Ð
Avoid placing 2 GPS devices too close during positioning.
Ð
it takes much time to get acquisition.
Ð Ð
It may take a long time to track the location under following two situations:
Ð
• The WPL-2000 didn't be operated more than 3 months.
• The distance between your current location and the last time device turn off location
is more than 800 km.
At this moment, cold star is suggested. For details, refer to "Cold Start" on page 28.
There are some shifted points with incorrect velocity and
Ð Ð
position in your track.
When you stay somewhere without movement or the moving speed is less then 10km/hr
Ð
or under the environment with tall buildings, the satellite signal is too weak to calculate
the accurate data. It's a GPS character, just move to open sky area and keep moving to
get better GPS signal.
You press the power button, but the unit is not turned on.
Ð Ð
Batteries may not be located properly.
Ð
Locate batteries properly according to the procedures in "Inserting Batteries" on page 5.
You may have used batteries with lower remaining power. Replace batteries with new
Ð
one.
Your computer does not Auto-run the WPL-2000.
Ð Ð
When the Auto-Run function is not working, please refer to MSDN-Enabling And
Ð
Disabling AutoRun:
http://msdn2.microsoft.com/en-us/library/Aa969329.aspx
You also can execute the WPL-2000 manually. Please refer to below process.
Ð
• Open "My Computer".
• Double click the icon of WIN_TOOL as following.
42