Gps Setting - Wintec WPL-2000 User Manual

2.
3.

GPS Setting

Ð
1. Tab: GPS Setting Tab.
2. GPS Mode: Select a GPS Mode here. Please be aware that the higher accuracy is
selected, the longer acquisition time is needed.
3. GPS Parameters: In point 2, if the "User define" is selected, the detail can be set here.
4. SBAS: Enable or disable SBAS function.
5. Set: After confirming GPS Parameters & SBAS, please press "SET" button to save it.
6. Cold Start:
• Cold Start is suggested if one of below mentioned is confirmed.
a) The WPL-2000 didn't be operated more than 3 months.
b) The distance between your current location and the last time device turn off
location is more than 800 km.
• Press the "Cold Start" button to reset almanac data inside the device, and speed up
the acquisition time.
• Cold Start also can be done by manually. Press and hold both function and track
buttons, and then push the power button to turn the device on simultaneously.
• Please be aware that the function of cold start manually will not work when the
battery is low.
1.
24
6.
4.
5.