Related Manuals for Wintec WBT-202
Summary of Contents for Wintec WBT-202
- Page 1 WBT-202 Bluetooth gPs Receiver with micro-sD interface USER'S MANUAL EngLIsh • 繁體中文...
-
Page 2: Table Of Contents
Return to original dealer immediately if it emits strange smell or fume. ● COnTEnTs UsIng ThE UnIT Set the WBT-202 on the place where can receive GPS signal easily BaTTERy InsTaLLaTIOn for 10 to 15 minutes if it is the first time to be used. This procedure BaTTERy REPLaCEmEnT... -
Page 3: Product Overview
No Micro-SD card. (Orange) Micro-SD card full. Micro-SD card error. (Log to the backup memory inside 1 Power Button 4 Bluetooth LED the WBT-202) 2 Flag Button 5 Power LED Log to Micro-SD card 3 GPS LED 6 Carrying Strap Hole Blink... -
Page 4: Using The Unit
Press the (Flag) button longer until the green (GPS) LED goes out, and the WBT-202 will re-start a new file for logging. Add a Push-To-Log point Press the (Flag) button to log a Push-To-Log point. Power Off... -
Page 5: Battery Installation
Please take off the battery if the device will not be operated more than 30 days. Be sure WBT-202 has been turned the power off before removing the battery. The abnormal process may cause damage of log data. Charge the battery immediately when the red (Power) LED blinks. -
Page 6: Battery Replacement
Before installing the Micro-SD card, please turn off the WBT-202, for charging. remove the battery and take off the USB cable if any. For the fi rst time using WBT-202, please charge battery until it is Install the Micro-SD card properly. Please refer to below illustration. fully charged. -
Page 7: Switch To Msd (Mass Storage Device) Mode
ShOwiNg TrAck & SETTiNg (MASS STOrAgE dEvicE) Enter the MSD mode (please refer to above process). Turn on the WBT-202 Connect the unit to any USB port of computer via USB cable. The inbuilt access tool (WBT_Tool) will be executed automatically... - Page 8 You probably can not see the above dialogue if the antivirus P.S. For the detailed user manual of WBT-202 and further instruction program in your computer does not accept the “Auto Run” function. of WBT_Tool, please refer to the electronic file inside the WBT_Tool Please change the setting to accept it.
-
Page 9: Usb Driver Installation
“… \ my document \ WBT202”. Press the (Flag) button to leave MSD mode. Turn on the WBT-202 and connect to computer via USB cable. At WBT-202 this moment, the computer will auto-detect the new USB device and ask for the software installation. The Found New Hardware...
Need help?
Do you have a question about the WBT-202 and is the answer not in the manual?
Questions and answers