Panic Mode; Quick Lockout; Cold Weather Mode - Directed Electronics SmartStart User Manual

(1) CMVLT = Combo Valet (Starter and Alarm are disabled)
(2) VLTST = Valet Start (Only the starter is disabled)
(3) VLTAM = Valet Alarm (Only the alarm is disabled)
iv) Once the selection is done, press .
v) Choose OFF, then press and hold
(1) The icon disappears to confirm Combo Valet deactivation.
(2) The icon disappears to confirm Valet Start deactivation.
(3) The icon disappears to confirm Valet Alarm activation.
If someone attempted to remote-start the vehicle while in Valet Mode; the parking lights will turn
ON, then OFF, then will flash twice.

Panic Mode

In an emergency situation, you can activate panic mode by pressing and holding the
button until the siren starts to sound. If the vehicle is under a remote start, the engine will shutdown
automatically before setting off the Siren. You can stop the Siren by pressing
Furthermore, the panic mode can be stopped by activating Valet Mode (page 13)
* Panic Mode will automatically shut down after 30sec.

Quick Lockout™

(Also called Secure Panic.) For fast protection in emergency situations, the system will LOCK all
doors when you press the brake pedal while you hear the Siren sounding. (Quick Lockout is only
available when Panic mode has been triggered.)

Cold Weather Mode

If the vehicle has a Manual transmission, Ready mode (page-9) should be set before entering
Cold Weather. When cold weather mode is active, the engine starts every 2 hours and runs for
3 minutes (or for 8 or 20 minutes with diesel engines). Cold weather mode automatically ends after
24 hours (or 12 starts).
To enter Cold Weather Mode:
2-way remote:
1. Through advance function remote's menu (page-6), select L-01.
2. Press and hold the button until the
OR
1-way remote:
1. Rapidly press AUX twice. While the remote's LED is flashing, press and hold
the parking lights flash for 2 seconds, pause, and then flash 3 times.
To exit Cold Weather Mode, do any one of the following actions:
x Open the hood.
x Start the engine remotely.
x Turn the ignition key to the IGNITION ON (RUN) position.
x Or by using the remote as so:
2-way remote
x
Through advance function remote's menu (page-6), select L-01.
Press and hold the button until the
User Guide
until;
OR
icon will appear on the display.
icon will disappear on the display.
OR
until
P.15