Attaching Blade Guard
TO PrEVENT SErIOUS INJUry: Unplug the Table Saw before this procedure.
BLADE GUArD MUST BE INSTALLED BEFOrE USE.
Figure N
1. Set the Blade Guard on top of the
Riving Knife so that the Roller slides into
the slot at the top of the Riving Knife.
Push it to the back of the slot. See Figure N.
Attaching and Adjusting the Fence
WArNING! Before installing the Fence,
make sure the Table Saw is disconnected
from its electrical power source.
Fence (121)
Fence
Rear
Plate
(125)
Figure Q
1. To attach Fence (121) to Work Table (91),
raise Fence Handle (110) and slip
the Fence Rear Plate (125) over the
back edge of Table. See Figure Q.
2. Lower the Fence all the way onto the Table and
lock in position by lowering the Fence Handle.
ITEM 69480
Fit Roller
into Slot
Fence
Handle
(110)
Work Table (91)
For technical questions, please call 1-888-866-5797.
Figure O
2. Press in the Guard Lock Button and lower the
Blade Guard to lock it in place. See Figure O.
Figure P
3. Make sure the Blade Guard is fully engaged,
aligned properly and does not contact the Blade.
3.
To adjust the position of the Fence, raise the Fence
Handle and slide the Fence along the Work Table.
Once position is adjusted, lower the Fence Handle
to lock the Fence in place. See Figure R.
4. WArNING! Make sure fence is perfectly
parallel to the blade and completely
locked in place to prevent kickback.
WArNING! Do not use fence when cutting
across wood grain (crosscutting).
Guard Lock
Button
Figure R
Page 13