Chicago Electric 69480 Owner's Manual & Safety Instructions page 8

Setup - Before Use:
Read the ENTIrE IMPOrTANT SAFETy INFOrMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PrEVENT SErIOUS INJUry FrOM AccIDENTAL OPErATION:
Turn the Power Switch of the tool to its "OFF" position and unplug the tool from its
electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Mounting Table Saw
If mounting onto a metal table stand:
1. Select a table stand which will support
the weight of the Table Saw. Follow the
table saw stand instructions for assembly.
Tighten all connections, making sure the
assembled table is secure and balanced.
2. Mount the Table Saw to the top of the assembled
stand using four 3/8" bolts, eight 3/8" washers
and four 3/8" nuts (not included).
Page 8 For technical questions, please call 1-888-866-5797.
If mounting onto a bench or
other wooden surface:
1. Select four 3/8" bolts, eight 3/8" washers, and
four 3/8" nuts* (not included).
*
Screws and washers may be used instead, if desired.
2. Place the Table Saw where it will be mounted.
Make a mark in the center of each of the
4 mounting holes. Set the Saw aside.
3. WArNING! Before drilling the holes, make sure
that there are no electric wires, cables, utility lines
or other obstructions in the area to be drilled.
4. Drill the holes straight down, large enough
to allow your mounting hardware to fit.
5. Put the Saw in place and mount
using the hardware mentioned above.
Tighten all hardware securely before use.
ITEM 69480