Chicago Electric 69480 Owner's Manual & Safety Instructions page 14

Operating Instructions
Read the ENTIrE IMPOrTANT SAFETy INFOrMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TOOL SET UP
TO PrEVENT SErIOUS INJUry FrOM AccIDENTAL OPErATION:
Turn the Power Switch of the tool to its "OFF" position and unplug the tool from its electrical
outlet before performing any inspection, maintenance, or cleaning procedures.
TO PrEVENT SErIOUS INJUry:
DO NOT OPErATE WITH ANy GUArD DISABLED, DAMAGED, Or rEMOVED.
Moving guards must move freely and close instantly.
INSTALL GUArD BEFOrE USE.
raising And Lowering the Saw Blade
Height
Handle (29)
Adjusting the Saw Blade Angle
Lock Knob
(53)
Figure T
Page 14
Figure S
Height
Handle (29)
For technical questions, please call 1-888-866-5797.
When cutting for safety, the top edge of the
Saw Blade should rise no more than 1/4"
above the top edge of the workpiece.
To increase the Blade height, turn the
Control Wheel counterclockwise.
The Table Saw is capable of making cuts from
45° to 90°. It also features an Angle Scale and
Angle Indicator on the front side of the unit.
1. To adjust the angle of the Saw Blade (73),
unlock the Lock Knob (53) by turning it
counterclockwise. Push the Height Handle
(29) inward to engage the gear, then turn it until
the red pointer indicates the desired angle.
2. When an angle is set, hold the Height Handle
stationary with one hand and tighten the Lock
Knob clockwise to lock the Saw Blade in position.
ITEM 69480