Aastra 6755i User Manual page 68

Line Keys, Programmable Keys, and Softkeys
In active states, such as ringing, conference, connected, etc., all softkeys disappear except softkeys that have been set up
as line/call appearances, and any context dependent softkeys required for the active state, such as the Drop softkey in
the connected state. Typically, context dependent softkeys appear in the top left position and all line/call appearance
softkeys appear in the remaining positions.
Note:
In some situations, such as during a conference call, the line/call appearance softkeys may overwrite some of the con-
text dependent softkeys. In this case, instead of the Previous and Next softkeys, up or down icons,
5 and 2
the display. By using the
softkeys.
You use the Aastra Web UI to set a programmable key or softkey as a line.
Configuring a Line Key
You can set a key as an additional line on the 6755i. The key acts as a line that behaves the same as a hard line key. For
more information about the behavior of line keys, see
You use the Aastra Web UI to set a key as a line.
Aastra Web UI
Use the following procedure to set a key to function as a line. The procedure shows the softkey screens as an example.
1. Click on Operation->Softkeys and XML.
or
Click on Operation->Programmable Keys.
or
Click on Operation->Expansion Module <N>.
Softkeys
2. Select from "Key 1" through "Key 20".
3. In the "Type" field, select Line to apply to the key.
4. In the "Label" field, enter a label to apply to this key.
5. In the "Line" field, select a line to apply to this key.
Valid values are 5 through 9.
6. In the state fields, check (enable) or uncheck (disable) the states you want to apply to this softkey.
Programmable Keys
7. Select from "Key 1" through "Key 6".
8. In the "Line" field, select a line to apply to this key.
Valid values are 5 through 9.
61
navigation keys, you can access the same functionality as the Previous and Next
"Multiple Line and Call Appearances"
5 and 2
appear on
on page 54.
41-001386-00 REV01 – 06.2013