Remote Client Setup; Webcam Installation - SecurityMan iCamDVR User Manual

Picture Quality – is image picture quality during transmis-
sion. Picture quality ranges from Lowest, Low, Medium,
Higher, & Highest levels. The default value is higher.
NoTICe
The HTTP, Data, and Command ports can be altered or change
at anytime to avoid conflict.

Remote Client Setup

On the client side or the remote accessing computer(s),
open IE 5.0 or above, type in the WebCam server IP address
of the hosting computer in the Address (URL) to get to the
downloading screen as shown below in figure 84. Select
Live Surveillance and click on oK to download and install
the WebCam program on the remote client computer(s).
Select Remote Playback and click on oK to download and
install the RPb (Remote Playback) program on the remote
client computer(s). For detail on RPb, please proceed to
Remote Playback on page 57 (setup) and page 60 (use).
• Live Surveillance – is a remote WebCam program used
to access SuperDVR live view with PTZ controls over
the internet.
• Remote Playback – is a remote RPB (Remote Playback)
program used to access SuperDVR hosting computer(s)
for playback purposes.
52 | SecurityMan
Figure 84 - WebCam Download
NoTICe
In case the HTTP port setting is changed from the default port
80 to 81, connect to the host using the IP server of the host
follow by a port number. For example, the server's IP address
is 211.148.96.234, and the port number is 81, then input
http://211.148.96.234:81..

WebCam Installation

After the WebCam complete download, the computer will
prompt to install WebCam client software as shown in
figure 85 below.