SecurityMan iCamDVR User Manual page 41

Start by clicking on the Group Setting button
to differentiate and separate the presets into group(s). De-
cide how many of the 16 preset are to be in GROUP1, how
many preset are to be in GROUP2 and so on. For example;
by selecting GROUP1 from the drop down list and then
placing a check mark in front of Preset1, Preset2, Preset3,
Preset4 and Preset5 means that the first 5 preset belongs
to GROUP1 as illustrated below in figure 61. Finally set-
ting up the Dwell time by inputting a number to represent
the number of seconds that will take for GROUP1 presets
(first 5 preset) to rotate when GROUP1 becomes active and
click on SaVe to save the settings. Setup GROUP2~4 by
following the same procedures as in the example above.
Any one GROUP can be enabled by selecting GROUP1~4
from figure 59 to start auto dwelling.
When GROUP is active all the selected preset1 through
preset5 will auto dwell in sequence if GROUP1 were to
be selected or select any of the 16 preset to view the fix
preset position.
Figure 60 - Preset & GRoUP Configuration
Click button to exit out of GROUP setting
and get back to the Preset setting as shown in figure 60.
In Preset setting press the "Choose a Preset" button to
select 1 of the 16 preset positions and then the name of
Figure 59 - Preset and GRoUP select
the Preset location will appear under "Name". The "Name"
can be change by typing the new name into the name
field. Next is to manually control the PTZ camera image to
40 | SecurityMan