Configuration Control Panel - SecurityMan iCamDVR User Manual

Figure 48 - emap Camera View
NoTICe
1. The map tree currently supports up to three levels, any
levels exceeding three will be invalid.
2. Loading picture(s) to Emap, if any side of length or width
of the picture loading exceeds the size of the default
pixels frame will be enlarge or shorten to proportion and
standardize. The default picture frame pixels size is 833 by
678 resolutions.
3. In Emap interface, right click on camera will display live
camera image on the spot.
4. If "auto Show" is selected E-map will pop-up automati-
cally on alarm triggering, the E-map tab interface allows
setup for "Holding Time" for Auto Show to be automati-
cally closed. "auto Show" becomes invalid if e-map is
manually opened.
33 | SecurityMan
5. The building map in the E-map is for demonstration only,
and any other engineering merchant to make the practi-
cal map or drawing of map by own according to the actual
needs may be used to scan and save to the computer and
be use for Emap map.
P.T.Z Configuration Control Panel
icon from Config to enter the PTZ
Click on the
Configuration panel as illustrated below in figure 49.
PTZ configuration requires serial port on the computer in
order PTZ controls to operation; the serial port is called an
RS485 port. Once a PTZ protocol camera is plugged into
the computer via serial port, the serial port can then be
configured or selected from the Serial Port options in PTZ
Configuration.
NoTe: If the laptop or desktop do not have a serial port built in, a con-
verter such as RS485 to RS232 and then another adapter from RS232 to
USb can be applied to control the PTZ protocol (converters NoT included).
There are many other alternatives but this is one of the best and cheapest
ways to convert RS485 serial port to USb.
Protocol Configuration
Select between CAM1~CAM4 from the Channels list in
which the protocol camera is connected to. Then select