GB
ENB539TAS by Energer
IE
Straight cut
To make straight cuts parallel to the edge of the tile using the provided guide, drag it
on the table using the two rules (on the front and rear of the table) to implement the
desired distance from the disk and lock it in position with the lever.
For straight cuts that are not parallel to the edge of the tile, it will draw a cutting line
on the floor to serve as a visual guide.
Start the machine
Press the trigger (1-a) to start your tool and press the trigger (1-b) to stop your
tool.
1-b
1-a
Cutting narrow workpieces
(width less than 120 mm)
Adjust the parallel stop (4) to the width of workpiece you require.
Feed in the workpiece with two hands. Always use the push stick (11) in the area of
the saw blade (2).
Always push the workpiece through to the end of the splitter (5).
Caution! With short workpieces, use the push stick from the beginning.
NOTE: The push stick (11) must always be stored on the saw when not in use.
WARNING. Worn or damaged push sticks must be replaced immediately.
16
Operation
ENB539TAS by Energer
General operation
1. Check the product, its power cord and plug as well as accessories for damage before
each use. Do not use the product if it is damaged or shows wear.
2. Double check that accessories are properly fixed.
3. Always hold the product by its handle. Keep the handle dry to ensure safe support.
4. Ensure that the air vents are always unobstructed and clear. Clean them if necessary with
a soft brush. Blocked air vents may lead to overheating and damage the product.
5. Switch the product off immediately if you are disturbed while working by other people
entering the working area. Always let the product come to complete stop before leaving it.
Do not overwork yourself. Take regular breaks to ensure you can concentrate on the work
and have full control over the product.
The golden rules of care
1. Keep the product clean. Remove debris from it after each use and before storage.
2. Regular and proper cleaning will help ensure safe use and prolong the life of the product.
3. Inspect the product before each use for worn and damaged parts. Do not operate it if you
find broken and worn parts.
WARNING! Always switch the product off, disconnect it
from power supply and let the product cool down before
performing inspection, maintenance and cleaning work!
WARNING! Only perform repairs and maintenance
work according to these instructions! All further works
must be performed by a qualified specialist!
General cleaning
1. Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
In particular clean the air vents (7) after every use with a cloth and brush.
2. Remove stubborn dirt with high pressure pressure air (max 3 bar).
3. Check for worn or damaged parts. Replace worn parts as necessary or contact an
authorised service centre for repair before using the product again.
NOTE: Do not use chemical, alkaline, abrasive or other
aggressive detergents or disinfectants to clean this
product as they might be harmful to its surfaces.
Operation
GB
IE
17
Need help?
Do you have a question about the ENB539TAS and is the answer not in the manual?