Care And Maintenance; Trouble Shooting; Recycling And Disposal; Power Cord - Energer ENB539TAS User Manual

GB
ENB539TAS by Energer
IE

Power cord

If the power cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a safety hazard.
UK plug
> As the colours of the wire in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows. The wire, which is coloured blue, must be
connected to the terminal, which is marked with N or coloured black. The
wire, which is coloured brown, must be connected to the terminal, which is
marked L or coloured red.
> No connection is to be made to the Earth terminal of the plug.
> Only fit an approved 13 Amp BS1363/a plug and the correct rated fuse.
> If in doubt, consult a qualified electrician.
> NOTE: If a moulded plug is fitted and has to be removed take great care in
disposing of the plug and severed cable, it must be destroyed to prevent
engaging into a socket.
Repair
1. This product does not contain any parts that can be repaired by the
consumer. Contact a qualified specialist to have it checked and repaired.
Storage
1. Clean the product as described above.
2. Store the product and its accessories in a dry, frost-free place.
3. Always store the product in a place that is inaccessible to children. The
ideal storage temperature is between 10 and 30°C.
4. We recommend using the original package for storage or covering the
product with a suitable cloth to protect it against dust.
Transportation
1. Switch the product off and disconnect it from power supply before
transporting it anywhere.
2. Attach transportation guards, if applicable.
3. Always carry the product by its handle.
4. Protect the product from any heavy impact or strong vibrations which may
occur during transportation in vehicles.
5. Secure the product to prevent it from slipping or falling over.
20

Care and maintenance

ENB539TAS by Energer

Trouble shooting

Suspected malfunctions are often due to causes that the user can fix
themselves. Therefore check the product using this section. In most cases the
problem can be solved quickly.
Problem
Possible cause
1. Product does 1.1 Not connected to
not start power supply
1.2 Power cord or plug
is defective
1.3 Other electrical
defect to the product
2. Product does not 2.1 Extension cord not
reach full power suitable for operation
with this product
2.2 Power source (e.g.
generator) has too low
voltage
2.3 Air vents are
blocked
3. Unsatisfactory 3.1 Accessory not
result suitable for work piece
material
WARNING! Only perform the steps described within
these instructions! All further inspection, maintenance
and repair work must be performed by an authorised
service centre or a similarly qualified specialist if you
cannot solve the problem yourself!

Recycling and disposal

Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your Local Authority or local store for recycling advice.
Trouble shooting GB
IE
Solution
1.1. Connect to power
supply
1.2. Check by a specialist
electrician.
1.3. Check by a specialist
electrician
2.1. Use a proper
extension cord
2.2. Connect to another
power source
2.3. Clean the air vents
3.1. Use proper accessory
21