FR
GB
ENB539TAS by Energer
IE
IE
Install the rip fence
> Adjust the rip fence (4) to the desired width from the blade using
the scale rules on the table surface for reference. To adjust loosen
the two securing knobs (8) (one at each end).
4
8
Install the mitre guide
> Follow the same procedure for a straight cut but employ the
mitre guide (3) in conjunction with parallel guide fence (4).Ensure
that the workpiece is held firmly into the guide before making the
cut.
4
12
Before you start
3
ENB539TAS by Energer
Mounting the table saw
> Locate the mounting holes (14) and set the table on the bench using "M6"
roundhead screws (minimum 40 mm length) or nuts and bolts (M6x40mm)
(not provided).
Dust extraction
WARNING! Attach a dust extraction device when using
this product in order to keep the working area clean! Wear
a dust mask when operating this product! Dust can be
harmful to health! Especially dust and chips of wood that
has been treated, e.g. with a wood preservative or stain!
> Attach a dust extraction device e.g. a suitable vacuum cleaner to the
vacuum adaptor(7).
Connection to the power supply
> Connect the plug with a suitable socket.
WARNING! Check the voltage! The voltage must comply with the
information on the rating label!
> Your product is now ready to be used.
WARNING! Do not use until the product has been
securely installed to a work bench.
Before you start
14
GB
IE
13
Need help?
Do you have a question about the ENB539TAS and is the answer not in the manual?