Cash Drawer Cables; Power Supply Cable - Wincor Nixdorf TH210-3 User Manual

_____________________________________________________________________

Cash Drawer Cables

The Cash Drawer Cable connects the printer to one or two cash
drawers.
1) Open Connector Cover at rear of printer if not previously open.
2) Plug the cable into the Cash Drawer Connector (standard phone
jack) located at the rear of the printer (see illustration on previous
page.)
Note: Leave some slack in the cord to route through the Strain Relief at

Power Supply Cable

Connect the Power Supply Cable last.
1) Plug the Power Cord into the 3pin HOSIDEN socket located at the
rear of printer
2) Snap the Connector Cover closed, ensuring that the Communication,
Cash Drawer and Power Supply Cables are aligned with the slots
provided for each in the Connector Cover. Verify that the strain relief
on the Connector Cover aligns with Power Supply Cable.
3) Plug the Power Supply Cable into the 3pin HOSIDEN socket of the
POS system. The Green LED on the top cover will light up.
_________________________________________________________
a later time.
TH210-3 for MF
9