Table of Contents
Advertisement
_____________________________________________________________________
1) Open the Rear Cover by pushing up on each side of the cover until it
unsnaps. Remove the Test Printout.
2) Lift the Starter Paper Roll out of the paper bucket and slide the two
Paper Roll Supports off.
3) Remove all tape on the leading edge of the roll.
4) Place the Starter Paper Roll back into the bucket so that it unrolls
from the bottom.
5) Close the Rear Cover.
Choose a location
Position your printer in a location that allows access to the cables, room
to open the cover and away from traffic areas to limit the chance of
being knocked or damaged. Observe the safety instructions on pages 2
and 3.
_________________________________________________________
TH210-3 for MF
7
Advertisement
Table of Contents
