Canon iR3530 Manual page 144

3
5
3-20
Changing the Copy (Zoom) Ratio
❑
Press [OK].
You can enter either the width or the length of the original size. If you enter the width for the
original size, make sure to enter the width for the copy (record) size as well, and vice versa.
The machine automatically calculates the correct copy (zoom) ratio based on the values you
entered; however, the original image may be cut off slightly depending on the paper (record)
size.
If the computation results in a zoom ratio greater than 200%, place your original on the
platen glass.
If the computation results in a zoom ratio less than 25% or greater than 400%, a message
appears telling you that values below 25% will be set to 25%, and values above 400% will be
set to 400%.
The selected mode is set, the display returns to the Copy Basic Features screen and the
copy (zoom) ratio generated by the machine is displayed.
NOTE
• For instructions on entering values in inches, see Chapter 2, "Basic Operations," in the
Reference Guide.
• To specify the horizontal (X) and vertical (Y) axis independently, press [XY Zoom].
Press .
Copying starts.
NOTE
• To return the copy (zoom) ratio to 100%, press [1:1].
• To cancel this setting, press [Copy Ratio]
• To cancel all settings and return the machine to the Standard mode, press
➞ ➞
[Other Zoom] [Zoom Program]
➞
[Cancel].
.