Infrared Mode; Irc-6 Operations - Chauvet Freedom Par Hex-4 User Manual

Infrared Mode

IRC-6 Operations

Note: The IRC-6 will not respond to any inputs when the Black Out mode is activated. If the remote does not respond when a button
is pressed, try pressing <BLACK OUT>. You may have inadvertently activated the Black Out mode.
Freedom™ Par Hex-4 User Manual Rev. 1
Infrared (IR) mode allows the product to be controlled with an infrared remote controller. The
IRC-6 can remotely set the product to various modes; adjust the color, speed and sensitivity; and set the strobe.
The Freedom™ Par Hex-4 is compatible with the included IRC-6 from Chauvet. To enable use with the IRC-6,
follow the instructions below:
1. Press <MENU> repeatedly until SET shows on the display.
2. Press <ENTER> and On (turns on the infrared sensor) or OFF (turns off the infrared sensor) shows on the
display.
3. Press <UP> or <DOWN> to select the desired option.
4. Press <ENTER>.
Be sure the IRC-6 remote is pointing directly at the product and there is nothing in between the remote and
the product.
Automatic Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
1. Press <AUTO> on the IRC-6.
2. Press <+> or <–> to choose between the four different auto programs.
To adjust the speed of the automatic program:
1. Press <SPEED> on the IRC-6.
2. Press <%>.
3. Press <+> or <–> to either increase or decrease the speed of the program.
Sound-Active Mode
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
·
Press <SOUND> on the IRC-6.
To adjust sound sensitivity in Sound-Active mode:
1. Press <SENSITIVITY> on the IRC-6.
2. Press <%>.
3. Press <+> or <–> to either increase or decrease sound sensitivity.
Manual Color Control
To choose a specific color with the IRC-6:
1. Press <MANUAL> on the IRC-6.
2. Press any number between <0> and <9> to choose your color.
To manually control the RGBAW+UV percentage:
1. Press <MANUAL> on the IRC-6.
2. Press <R>, <G>, <B>, <A>, <W>, or <UV> (red, green, blue, amber, white, or ultraviolet) to choose
your color.
3. Press <+> or <–> to increase or decrease the percentage of each color.
Miscellaneous Operation
To adjust the strobe rate of the program:
1. Press <STROBE> on the IRC-6.
2. Press <+> or <–> to increase or decrease the strobe rate.
3. Press <STROBE> again to turn off the strobe.
To choose a fade auto program:
·
Press <FADE> repeatedly on the IRC-6 to choose between the two auto program fade options
To black out the lights:
·
Press <BLACK OUT> on the IRC-6. This will turn off all the lights until the button is pressed again.
Page 17 of 21