Yamaha 01v 96 Service Manual page 116

01V96
The following options are available:
• ALL................................. This button selects all data available for bulk dump. When this button is turned on, all other
• SCENEMEM....................This button selects Scene memories. You can select Scenes you wish to transmit in the parameter
• LIBRARY......................... This button selects libraries. You can select the type of library in the TYPE parameter box (next
• BANK.............................. This parameter enables you to select the User Defined Key banks (KEYS UDEF), User Defined
• SETUPMEM ................... This button selects the 01V96 setup data (i.e., system settings).
• PGM TABLE ...................This button selects the MIDI | Pgm Asgn page settings.
• CTL TABLE..................... This button selects the MIDI | Ctl Asgn page settings.
• PLUG-IN......................... This button selects the settings of an optional Y56K card installed in the slot. You can select
Note: Data selected by the SETUPMEM button includes MIDI transmission and reception port settings and message
settings. After you store to an external device bulk dump data that has its reception disabled, if the 01V96 later starts to
receive this particular data, 01V96 bulk dump reception will be turned off immediately, and the 01V96 will be unable to
receive sub-sequent data. Therefore, before you store the data selected by the SETUPMEM button using Bulk Dump, be
sure to enable bulk data transmission and reception.
5 If necessary, move the cursor to the parameter box next to the selected button, then rotate the Parameter wheel or
press the [INC]/[DEC] buttons to select the desired bulk dump data.
Tip: If you selected [ALL] in the parameter box, all data selected by the corresponding button is transmitted as bulk dump
data.
6 To start transmitting bulk data, move the cursor to the TRANSMIT button, then press [ENTER].
Bulk Dump is executed. During the operation, the Bulk Dump window appears, indicating the current bulk dump status. To
abort the bulk dump operation, move the cursor to the CANCEL button in the window, then press [ENTER].
Tip: To transmit bulk dump request messages, move the cursor to the REQUEST button, then press [ENTER]. If you set
up the 01V96 so that it will transmit and receive MIDI messages to and from another 01V96, the other 01V96 will respond
to the bulk dump request and transmit the bulk dump data to the 01V96 you are operating.
7 To receive bulk data, press the DISPLAY ACCESS [MIDI] button again to display the MIDI | Setup page, then turn on
the Rx ON/OFF button in the BULK row.
Now, when the 01V96 receives bulk data, the corresponding internal data is updated.
116
buttons in this section are turned off.
box next to the button.
to the button), then specify the library number in the parameter box on the right.
Remote Layer banks (RMD UDEF), or User Assignable Layer banks (USR LAYER) for bulk
dump. You can select one of these three types in the parameter box next to the button, and select
the banks in the parameter box on the right.
Y56K card programs in the parameter box next to the button..