Yamaha 200A Service Manual page 216

BRKT
2. Check the tilt piston and free piston for
scratches. Replace if necessary.
3. Air blow the contamination on the tilt pis-
ton absorber valve. Check the valve for
wear, and check the spring for deteriora-
tion.
4. Check the tilt rod for bends or corrosion.
Replace if necessary.
5. Check the trim piston for scratches. Re-
place if necessary. Check the trim rods for
bends or corrosion. Replace if necessary.
7-35
Bracket unit
60h70800
60h70810
60h70820
6. Remove the filter plug and filter from the
tilt cylinder, and check them.
7. Check the inner walls of tilt cylinder and
trim cylinder for scratches. Replace if nec-
essary.
8. Install the filter and filter plug on the tilt cyl-
inder.
Filter plug:
6 N • m(0.6 kgf • m, 4 ft • lb)
9. Install a new O-ring 23 and the dust seal
1 on the tilt cylinder end cap.
60h70830
60h70850
A A
60h70860
60H5E11