Removing The Drive Shaft And Reverse Gear; Disassembling The Lower Case - Yamaha 200A Service Manual

LOWR
Removing the drive shaft and reverse
gear
NOTE:
Shimming is required when the reverse gear
or taper roller bearing is replaced.
1. Loosen the pinion nut.
Drive shaft holder 6 1: 90890-06520
Socket adapter 3 2: 90890-06508
Pinion nut holder 2: 90890-06505
2. Remove the drive shaft housing.
NOTE:
Note that the pinion gear shims may be stuck
on the drive shaft housing.
3. Pull out the drive shaft, and remove the pin-
ion gear.
4. Remove the drive shaft sleeve.
NOTE:
Make sure that none of the needles of the drive
shaft needle bearing is missing.
6-47
Lower unit
60h60310
5. Remove the reverse gear.
SST Bearing puller assembly:
90890-06535

Disassembling the lower case

NOTE:
Remove the lower case only when shimming
is required for the forward gear, or when re-
placing the taper roller bearing or needle bear-
ing.
1. Remove the roller bearing.
Bearing outer race puller assembly 1:
90890-06523
60h61323
60h61327
60H5E11