Table of Contents
Advertisement
Toggle Pin 6 to position 0 to disable the link down alarm.
Reconnect the converter to the power supply. The new setting(s) will then take effect.
Front Panel & LEDs
LED Indicators
The LED indicators give you instant feedback on the status of the converter:
LEDs
FAULT
PWR1
PWR2
100 (Mbps)
LFS
LNK/ACT
FDX/COL
6
065-1800 series Hardened Media Converter
State
Steady
Power or ports function abnormally
Off
Power and ports function normally
Steady
PWR stands for POWER
Off
Steady
Connection speed is 100 Mbps
Off
Connection speed is 10 Mbps
Steady Link Fault Signaling function enabled
Off
Link Fault Signaling function
Steady
A valid network connection
Flashing
Transmitting or receiving data
ACT stands for ACTIVITY
Off
Neither valid network connection
transmitting/receiving data.
Steady
Connection in full duplex mode
FDX stands for FULL-DUPLEX
Flashing
COL stands for COLLISION
Off
Connection in half-duplex mode
Indication
Power on
Power off
disabled
established
LNK stands for LINK
established nor
Collision occurred
User's Manual
Advertisement
Table of Contents
