Keyboard Connection (Only Divar 5000); Connect Using Rj11 Adapter; Connect Wires Directly - Bosch DIVAR AN 5000 Operation Manual

30 en | Hardware setup
5.4

Keyboard connection (only DIVAR 5000)

Use the keyboard connection on the back of the DIVAR AN 5000 to connect a Bosch Intuikey
keyboard using one of the following methods:
–
–
For short distances (up to 30 m), standard 6-core telecom flat cable can be used to supply
signal connections for the keyboard (LTC 8558/00). Always use the Keyboard Extension Kit
(LTC 8557) for distances over 30 m between the keyboard and the DVR; this kit provides
junction boxes and cables. Maximum cable length: 30 m (using standard 6-core telecom flat
cable), or 1.5 km (using Belden 8760 or equivalent).
The appropriate power supply (11 - 12.6 VDC, maximum 400 mA) to externally power the
keyboard must be purchased separately.
5.4.1

Connect using RJ11 adapter

Connect the adapter as follows:
–
–
–
–
Figure 5.1: RJ11 adapter connections
5.4.2

Connect wires directly

1.
2.
2015.02 | 2.1 | AM18-Q0669
use the supplied RJ11 adaptor – see Connect using RJ11 adapter, page 30
strip the keyboard cable (or equivalent cable) to connect leads directly – see Connect
wires directly, page 30
red cable to the (-) of the keyboard control connector
green cable connects to the (+) of the keyboard control connector
white cable to ground
blue cable to +12V
+ _
G G G
power to
keyboard
DVR
RS-485 KEYBOARD
Cut off one of the connectors at the end of the cable.
Strip cable wires 1, 3, 4 and 6.
+ _
G
keyboard
control
Operations Manual
DIVAR AN 3000 / DIVAR AN 5000
Bosch Security Systems