Funkwerk bintec R230a User Manual page 10

2
BOOT Sequence
Note
8 bintec User's Guide
3. Software update via XMODEM:
The gateway performs a software update over a serial interface with XMO-
DEM.
4. Delete configuration:
The gateway is reset to the unconfigured ex works state. All configuration
files are deleted and the BOOTmonitor settings are set to the default val-
ues.
5. Default BOOTmonitor parameters:
You can change the default settings of the gateway's BOOTmonitor, e.g.
the baud rate for serial connections.
6. Show system information:
Shows useful information for the gateway, e.g. serial number, MAC ad-
dress and software versions.
If you change the baud rate (the preset value is 9600 baud), make sure the ter-
minal program used also uses this baud rate. If this is not the case, you will not
be able to establish a serial connection to the gateway!
Gateway Management