Heart Rate Zones - Epson PS-100 Series User Manual

When the heart rate can't be detected
LED

Heart rate zones

You can check your heart rate zone using the product LEDs. Setting can be made via PULSENSE View to
determine when the LEDs will illuminate. See below table for the available settings.
LED
Issue
It is likely that the device is not
fitted correctly onto your wrist.
It is likely that the device is not
fitted correctly onto your wrist or
the temperature on the surface of
your skin is too low.
% of max.
heart rate
TAP
Under 40% Blinking
40～49%
↑
50～59%
↑
60～69%
↑
70～79%
↑
80～89%
Above 90%
Wear the product closely around
your wrist. Tighten the wrist band if
your pulse is not measured
correctly.
Wear the product closely around
your wrist. Tighten the wrist band if
your pulse is not measured correctly
and warm your wrist and fingertips if
they seem cold.
LED settings
FLASH
OFF
(If you tap, the LED will blink)
Blinking
↑
↑
↑
↑
Blinking (Faster)
How to solve
OFF
ON
-
-
ON
-
↑
-
↑
-
↑
-
↑
-
How to Use  24