Troubleshooting - Allen + Roth 3MVR44BSD User Manual

TROUBLESHOOTING
If you have any questions regarding the product, please call customer service at 1-866-439-9800, 8
a.m. - 6 p.m. , EST, Monday- Thursday, 8 a.m. - 5 p.m. , EST, Friday.
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Fan doest not start 1 . Power is off.
1 . Check main and branch fuses
2. Pull chain switch is off.
or circuit breakers.
3. Reverse switch does not engage.
2. Pull the pull chain switch.
4. Faulty wire connection.
3. Push the switch firmly either
5. Out of battery (Transmitter).
way.
6. Dip switchs does not match.
4. Turn power off and check all
wire connections.
5. Replace battery.
6. Check dip switches setting.
Fan sounds noise 1. Set screws are loose. 1 . Tighten all set screws.
2. Faulty light bulb installation. 2. Check to be sure light bulb is
3. Glass is not secure. tight in cocket and not touch
4. Unapproved speed control. on glass shade.
3. Secure the glass.
4. Replace with an approved
speed controller.
Excessive wobbling
1. Blades or blade holders are loose. 1. Tighten all set screws of blades
2. Unbalanced blades. and blade holders.
3. Mounting bracket is not secure. 2. Switch blade with a blade from
4. Set screws on yoke are not secure. the opposite side.
5. Downrod ball does not engage. 3. Turn power off. Loosen canopy
6. Fan too close to vaulted ceiling. and make sure that mounting
bracket is secure.
4. Tighten the set screws.
5. Make sure that the ridge on
mounting bracket engages the
notch in the downrod ball.
6. Use longer downrod or move it
to other locations.
Light does not work 1. Faulty wire connection.
1. Turn power off and check all
2. Faulty plug connection. wire connections.
3. Faulty light bulbs. 2. Remove light kit and check plug
4. Bulbs does not install well. connection.
5. Over Iamping and result in the light 3. Replace bulbs.
shut down .
4. Turn power off. Reinstall bulbs.
.
6. Out of battery (Transmitter). 5. Turn power off and replace with
7. Dip switches does not match. correct bulbs. Turn power on.
6. Replace battery.
7. Check dip switch setting.
14