Page 1
ITEM #2889551 ALLEN + ROTH and logo design are trademarks or registered trademarks VALDOSTA PORTABLE FAN of LF, LLC. All rights reserved. MODEL #L1120H-WH Español p. 10 ATTACH YOUR RECEIPT HERE Serial Number Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-866-439-9800, 8 a.m.
TABLE OF CONTENTS Pack age Contents....................... H ardware Contents......................Safety Information....................... Preparation ......................... Assembly Instructions......................O perating Instructions ......................Care and M aintenance ....................... Troubleshooting........................Limited Lifetime W arranty....................R eplacement Parts List ......................
PACK AGE CONTENTS PART DESCRIPTION Q UANTITY Downrod Assembly Coupling Cover R od Clip M otor Body W ire Clip Coupling (Preassembled to the M otor Body (D)) Cross Pin (Preassembled to Coupling (F)) Clip (Preassembled to Coupling (F)) Coupling Screw (Preassembled to Coupling (F))
HARDWARE CONTENTS (shown actual size) Set Screw Acorn Nut Qty. 1 Qty. 1 SAFETY INFORMATION READ AND SAVE THESE INSTRUCTION hanging structure can support the weight, do not attempt to install this fan as it may fall and cause regarding proper mounting methods in your area. the fan before installing, cleaning and servicing the item.
PREPARATION Before beginning assembly of the product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product. Estimated Assembly Time: 45 minutes Tools Required for Assembly (not included): Philips Screwdriver, Step Ladder, Tape and Pliers.
Page 6
ASSEMBLY INSTRUCTIONS 3. Insert downrod assembly (A) through coupling cover (B) into coupling (F). Make sure to align the hole in downrod assembly (A) with the hole in coupling (F). Install cross pin (G) through coupling (F) and downrod assembly (A). Insert clip (H) into cross pin (G) until it snaps into place.
ASSEMBLY INSTRUCTIONS 6. Peel the backing off the adhesive tape stripes on the bottom of the wire clips (E). Attach the wire clips (E) as needed to the wall or ceiling and press gently. Clip the power cord to the wire clips (E). Plug the power cord into a ground 3-prong outlet.
CARE AND MAINTENANCE IMPORTANT: Shut off the main power supply before beginning any maintenance. Do not use water or a damp cloth to clean the ceiling fan. blades with a lint-free cloth. situation. If the fuse blows, unplug the product from the outlet and replace the fuse as below: 1) G rab the plug and remove it from the receptacle or other outlet device.
LIMITED LIFETIME WARRANTY The manufacturer warrants this fan to be free from defects in workmanship and material present at time of shipment from the factory for life (with limitations) from the date of purchase. This warranty applies only to the original purchaser. The manufacturer agrees to correct such defect at no charge or, at our option, replace the ceiling fan with a comparable or superior model.
Need help?
Do you have a question about the VALDOSTA and is the answer not in the manual?
Questions and answers
Where is the dip switch on the Allen Roth ceiling fan P8150 on the receiver