Operation Instructions; Care And Maintenance; Troubleshooting - Allen + Roth 00882 Instruction Manual

FINAL INSTALLATION
15. Insert the plastic plug (DD) into the center hole in the
switch housing (I).
Hardware Used
DD
Plastic Plug x 1
16. Attach switch housing (I) to switch housing cover on
motor housing assembly (H). Align switch housing (I)
holes with switch housing cover holes. Install the
previously removed screws (Step 6, page 13) and
tighten securely.
17. Add fan pull chain extension (BB) to corresponding
chain.
Hardware Used
BB Fan Pull Chain Extension
15
DD
16
Switch
housing
cover
17
x 1
BB
Lowes.com/allenandroth
16

OPERATION INSTRUCTIONS

1. PULL CHAIN:
(1). The fan pull chain is for motor speed control: High, Medium, Low and Off. Pull the chain once
for each position.
2. REVERSE SWITCH:
When the season changes, you may want to change the direction the fan spins. To switch
I
NOTE: Wait for fan to stop before reversing switch.
which cools the air. Push the switch LEFT and see a Sun icon.
moves hot air from the ceiling into the room. Push the switch RIGHT and

CARE AND MAINTENANCE

• Important: Shut off main power supply before beginning any maintenance.
• Do not use water or detergents when cleaning the fan or fan blades. A dry dust cloth or lightly
dampened cloth will be suitable for most cleaning.
H
blades with a lint-free cloth. You may occasionally apply a light coat of furniture polish to blades for
added protection.
• At least twice each year, tighten all screws and lower canopy to check mounting bracket screws
and downrod assembly.
• Bulb Replacement: Use two 60-watt max. type A15 candelabra-base bulbs.

TROUBLESHOOTING

PROBLEM
I
Fan blades do not
move.
Noisy operation.
Excessive wobbling. 1. Blades are loose.
POSSIBLE CAUSE CORRECTIVE ACTION
1. Chain switch is "off". 1. Pull chain switch.
2. Faulty wire connection. 2. Turn power off. Loosen canopy;
3. Reverse switch not engaged. check all connections.
1. Blades are loose. 1. Tighten all blade screws.
2. Cracked blade. 2. Replace blades (call customer
3. Upapproved speed control. service).
3. Replace with an approved speed
control device.
1. Tighten all blade screws.
2. Blade brackets incorrectly 2. Reinstall blade brackets.
attached. 3. Switch with blade from opposite side.
3. Unbalanced blades. 4. Turn power off. Carefully loosen
4. Fan not securely mounted. canopy; remount securely.
5. Fan too close to vaulted ceiling. 5. Lower fan or move it to another
location.
17
Sun icon Snowflake icon
Lowes.com/allenandroth