Set Date And Time - AT&T TL96371 User Manual

Telephone settings
Handset and telephone base settings

Set date and time

The answering system announces the day and time of each message prior to
playing it. If you subscribe to caller ID service, the day, month and time are
set automatically with each incoming call. If you do not want to set the date
and time automatically with caller ID information, turn this feature off (see
Use caller ID to automatically set date and time on page 39). However, the
year must be correct so that the day of the week can be calculated from the
caller ID information. Before using the answering system, set the date and
time as follows.
After handset registration or a power failure,
will prompt you to set the date and time
To set the date and time:
MENU
1. Press
CID or DIR on the handset, or press CID or
2. Press
DIR on the telephone base to highlight Set date/time,
SELECT
then press
CID or DIR on the handset, or press CID or
3. Press
DIR on the telephone base to select the month, then
SET
press . , or enter the 2-digit number (01-12) using the
dialing keys (0-9).
4. Press CID or DIR on the handset, or press CID or
DIR on the telephone base to select the day, then
press SET . , or enter the 2-digit number (01-31) using the
dialing keys (0-9).
5. Press CID or DIR on the handset, or press CID or
DIR on the telephone base to select the year, then press
SET, or enter the 2-digit number (00-99) using the dialing
keys (0-9), then press
CID or DIR on the handset, or press CID or
6. Press
DIR on the telephone base to select the hour, then
SET
press . , or enter the 2-digit number (01-12) using
the dialing keys (0-9).
CID or DIR on the handset, or press CID or
7. Press
DIR on the telephone base to select the minute, then
SET
press . , or enter the 2-digit number (00-59) using
the dialing keys (0-9).
8. Press CID or DIR on the handset, or press CID or
DIR on the telephone base to highlight AM or PM, or
press 2 for AM or 7 for PM. Press
a confirmation tone.
NOTE:
If the date and time are not set when a message is recorded,
the system announces, "Time and day not set," before each message plays.
in idle mode to enter the main menu.
.
SET
.
the handset or telephone base
(see page 13).
SET to save. You hear
33
Cal ler ID log
Intercom
Ringers
Set date/time
BACK SELECT
SET DATE
09/30/10
MM/DD/YY
BACK SET
SET TIME
05:41 PM
BACK SET
Intercom
Bluetooth
Ringers
Set date/time
BACK SELECT
SET DATE
Active devices
01/01/11
MM/DD/YY
BACK SET
SET TIME
Active devices
06:08 PM
BACK SET