Answering system
Answering system settings
Message alert tone
When the message alert tone is set to On, the telephone base beeps every
10 seconds to alert you to new messages. The tone stops when all new
messages have been reviewed. By default, the message alert tone setting
is Off.
To change the setting:
Using a handset or telephone base:
MENU
1.
Press
CID or DIR on the handset, or
2.
Use
the telephone base
press
SELECT
3.
Use
CID or DIR on the handset, or
the telephone base
SELECT
press
CID or DIR on the handset, or
4.
Press
on the telephone base
press
SELECT
5.
Press
CID or DIR on the handset, or
on the telephone base
Off, then press
confirmation tone.
NOTES:
•
You cannot set the message alert tone when another handset or the telephone base is
accessing the answering system.
•
The message alert tone beeps only if all the conditions below are met.
–
Answering system is on.
–
Message alert tone setting is on.
–
There are new messages.
Temporarily turning off the message alert tone
Pressing any telephone base key (except
DELETE/X) temporarily silences the message alert tone. The message alert
tone plays with the next incoming message.
in idle mode to enter the main menu.
to scroll to Answering sys, then
.
to scroll to Ans sys setup, then
.
to scroll to Msg alert tone, then
.
to choose between On and
SET
to save your setting. You hear a
CID
or DIR on
CID
or DIR on
CID
or DIR
CID
or DIR
/HANDSET LOCATOR and
108
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
BACK
SELECT
MSG ALERT TONE
On
Off
BACK
SET
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
BACK
SELECT
MSG ALERT TONE
On
Off
BACK
SET