AT&T TL96371 User Manual page 77

Multiple handset use
Push-to-talk (PTT)
Using the telephone base:
1. To begin a PTT call to a group of devices:
• Press and hold PTT when the telephone base is not in use.
-OR-
• Press PTT when the telephone base is not in use, then press TONE
and # (pound key).
-OR-
Press PTT when the telephone base is not in use. Press CID
•
to highlight Group, then press
Your screen displays Connecting to group... for a few seconds. When the
connection is made, both screens display Press and hold [PTT] to talk
and beep once.
Press and hold PTT on the telephone base. A chirp indicates your
2.
microphone is on. Speak towards the microphone. Your voice is broadcast
to the destination handsets. While you are speaking, the screen displays
PTT To handset X (X represents the destination handset numbers).
3. Release PTT after speaking. All eligible handsets beep once again. After
the telephone base beeps, you can press and hold PTT to continue
speaking or the destination handsets can respond (see Answer a PTT call
on page 72).
4. Press CANCEL or
Push to talk Ended for a few seconds.
NOTE: After PTT is released, the PTT call remains open for a short time. If no one presses
PTT within 10 seconds, the PTT call ends automatically.
SELECT
END to end the PTT call. The telephone base displays
or PTT.
71
DIR
or