Table of Contents
Advertisement
EN
SECTION B
PARAPET AND PIPE MOUNTS
1
DESCRIPTION
This section details mounting of the AutoDome using the
Roof (parapet) or Pipe mount. Any differences concerning
these installations are noted herein.
The LTC 9230 Series are stationary mounts intended for rooftop
parapet vertical walls. Used for all Philips' AutoDome systems up
to a rated load of 29 kg (64 lb), these mounts are made of light-
weight aluminum with a corrosion-resistant finish. Mounts can
be fitted to the inside or outside of parapet walls, and can be
swiveled for ease of positioning, and servicing the AutoDome.
Either the ENV-PSU1 (120 V) or ENV-PSU2 (230 V) is included
in kits with transformers.
Pipe to
Dome Cap
LTC 9230/00 Parapet Mount
NOTE: 1.5-inch NPT pipe not included.
LTC 9543/00 Pipe Mount
© 2003 Bosch Security Systems
LTC 9230/01
Optional Roof
Mount Adapter
0.25 Typ.
0.41
4.37 Typ.
0.63 Typ.
0.63 Typ.
Top Mounting Flange & Gasket
Pipe to Dome Cap
ENV-PSU1(120 V)
ENV-PSU2 (230 V)
2
UNPACKING
Unpack carefully. This equipment should be handled with
care to prevent damage.
Check for the following items and part numbers:
APPLICABLE PRODUCT
Parapet Mount Kit:
Parapet Mount
Pipe to Dome Cap
Kits w/Transformer or Fiber Optics
include one of the following:
• Transformer -
120 VAC / 230 VAC
• Transformer w/Fiber Optic
Module - 120 VAC / 230 VAC
Bag of Parts (See below)
Optional Adapter for Above
(not included):
Flat Roof Mount Adapter
Bag of Parts (See below)
Pipe Mount Kit:
Top Mounting Flange
Gasket for above Flange
Pipe to Dome Cap
Kits w/Transformer or Fiber Optics
include one of the following:
• Transformer -
120 VAC / 230 VAC
• Transformer w/Fiber Optic
Module - 120 VAC / 230 VAC
Bag of Parts (See below)
10.00
Square
*Kits with AutoTracker end in "T".
Kits with Surge Protection end in "SP".
Bag of Parts:
The following items are shipped in a separate bag:
One (1) 3-pin power connector.
ν
Two (2) Rubber hole plugs.
ν
One (1) Green ground screw.
ν
One (1) Ring terminal for ground wire.
ν
One (1) 9-pin signal/power connector.
ν
One (1) 3-pin alarm connector (AutoTracker only).
ν
One (1) 6-pin signal connector (not included with fiber
ν
units).
If any items appear to have been damaged in shipment,
replace the item(s) properly in the shipping carton and notify
the shipping company. If any items are missing, notify your
Bosch Sales Representative or Customer Service
Representative.
Service Centers
U.S.A.: Phone: 800-366-2283 or 408-956-3895
fax:
800-366-1329 or 408-956-3896
e-mail: NationalServiceCenter@ca.slr.com
Canada:
514-738-2434
Europe, Middle East & Asia Pacific Region:
32-1-440-0711
For additional information,
see www.boschsecuritysystems.com.
Introduction
PART#
*
LTC 9230/00
303 3092 003
ENV-PSU1 / ENV-PSU2
ENV-PSU1F / ENV-PSU2F
LTC 9230/01
303 2457 007
303 2599 001
303 3092 003
ENV-PSU1 / ENV-PSU2F
ENV-PSU1F / ENV-PSU2F
Page 13 of 24
Hide quick links:
Advertisement
Table of Contents
