The Snat Status Screen - ZyXEL Communications UAG2100 User Manual

Table 213 Maintenance > Packet Flow Explore > Routing Status (continued)
LABEL
The following fields are available if you click 1-1 SNAT in the Routing Flow section.
#
NAT Rule
Source
Destination
Outgoing
Gateway
The following fields are available if you click Default WAN Trunk in the Routing Flow section.
#
Source
Destination
Trunk

44.3 The SNAT Status Screen

The SNAT Status screen allows you to view and quickly link to specific source NAT (SNAT) settings.
Click a function box in the SNAT Flow section, the related SNAT rules (activated) will display in the
SNAT Table section. To access this screen, click Maintenance > Packet Flow Explore > SNAT
Status.
The order of the SNAT flow may vary depending on whether you:
• select use default SNAT in the Configuration > Network > Interface > Trunk screen.
• use policy routes to control 1-1 NAT by using the policy control-virtual-server-rules
activate command.
Note: Once a packet matches the criteria of an SNAT rule, the UAG takes the
corresponding action and does not perform any further flow checking.
Chapter 44 Packet Flow Explore
DESCRIPTION
This field is a sequential value, and it is not associated with any entry.
This is the name of an activated 1:1 or Many 1:1 NAT rule in the NAT table.
This is the original source IP address(es). any means any IP address.
This is the original destination IP address(es). any means any IP address.
This is the name of an interface which transmits packets out of the UAG.
This is the IP address of the gateway in the same network of the outgoing interface.
This field is a sequential value, and it is not associated with any entry.
This is the source IP address(es) from which the packets are sent. any means any IP
address.
This is the destination IP address(es) to which the packets are transmitted. any means any
IP address.
This is the name of the WAN trunk through which the matched packets are transmitted.
UAG2100 User's Guide
433