Add/Edit White List Rule - ZyXEL Communications UAG2100 User Manual

To access this screen click Configuration > Network > Layer 2 Isolation > White List.
Figure 133 Configuration > Network > Layer 2 Isolation > White List
The following table describes the labels in this screen.
Table 98 Configuration > Network > Layer 2 Isolation > White List
LABEL
Enable White List Select this option to turn on the white list on the UAG.
Add
Edit
Remove
Activate
Inactivate
#
Status
IP Address
Description
Apply
Reset

22.3.1 Add/Edit White List Rule

This screen allows you to create a new rule in the white list or edit an existing one. To access this
screen, click the Add button or select an entry from the list and click the Edit button.
Note: You can configure up to 20 white list rules on the UAG.
Note: You need to know the IP address of each connected device that you want to allow
to be accessed by other devices when layer-2 isolation is enabled.
Chapter 22 Layer 2 Isolation
DESCRIPTION
Note: You can enable this feature only when the firewall is enabled.
Click this to add a new rule.
Click this to edit the selected rule.
Click this to remove the selected rule.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
This field is a sequential value, and it is not associated with a specific rule.
This icon is lit when the rule is active and dimmed when the rule is inactive.
This field displays the IP address of device that can be accessed by the devices connected
to an internal interface on which layer-2 isolation is enabled.
This field displays the description for the IP address in this rule.
Click Apply to save your changes back to the UAG.
Click Reset to return the screen to its last-saved settings.
UAG2100 User's Guide
209