Add/Edit Port Triggering Rule - ZyXEL Communications XMG3512-B10A User Manual

The following table describes the labels in this screen.
Table 59 Network Setting > NAT > Port Triggering
L ABEL
Add New Rule
#
Status
Service Name
WAN Interface
Trigger Start Port
Trigger End Port
Trigger Proto.
Open Start Port
Open End Port
Open Proto.
Modify
11.4.1 Add/ Edit Po rt T rig g e ring Rule
This screen lets you create new port triggering rules. Click
click a rule's
Port Triggering: Add/Edit
Fig ure 83
Chapter 11 Network Address Translation (NAT)
DESC RIPT IO N
Click this to create a new rule.
This is the index number of the entry.
This field displays whether the port triggering rule is active or not. A yellow bulb signifies that this
rule is active. A gray bulb signifies that this rule is not active.
This field displays the name of the service used by this rule.
This field shows the WAN interface through which the service is forwarded.
The trigger port is a port (or a range of ports) that causes (or triggers) the XMG to record the IP
address of the LAN computer that sent the traffic to a server on the WAN.
This is the first port number that identifies a service.
This is the last port number that identifies a service.
This is the trigger transport layer protocol.
The open port is a port (or a range of ports) that a server on the WAN uses when it sends out a
particular service. The XMG forwards the traffic with this port (or range of ports) to the client
computer on the LAN that requested the service.
This is the first port number that identifies a service.
This is the last port number that identifies a service.
This is the open transport layer protocol.
Click the icon to edit this rule.
Edit
Click the icon to remove an existing rule.
De le te
icon to open the following screen.
Edit
XMG3512-B10A User's Guide
Add ne w rule
156
in the screen or
Po rt T rig g e ring