Allied Telesis AT-9408LC/SP Installation Manual page 57

Stop bits: 1
Flow control: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
4. Press Enter.
You are prompted for a user name and password.
5. To configure the switch settings, enter "manager" as the user name.
The default password for manager access is "friend."To just view the
settings, enter "operator" as the user name. The default password for
operator access is "operator." User names and passwords are case
sensitive.
6. The local management session starts and the command line interface
(CLI) prompt is displayed, as shown in Figure 31.
Allied Telesyn Ethernet Switch AT-9448Ts/XP - AT-S63
#
For information about the command line interface, refer to the AT-S63
Management Software Command Line Interface User's Guide.
7. To use the menus interface, type menu and press Return.
The switch's Main Menu is displayed. For information, refer to the
AT-S63 Management Software Menus Interface User's Guide.
8. To select a menu item, type the corresponding letter or number. To
return to a previous menu, press the Esc key or type the letter R.
AT-9400 Series Layer 2+ Gigabit Ethernet Switches Installation Guide
<No system name>
Figure 31. CLI Prompt
57