Installing An Sfp Transceiver - Allied Telesis AT-9408LC/SP Installation Manual

Installing an SFP
Transceiver
2. Slide the GBIC transceiver into the slot until it clicks into place, as
shown in Figure 21. A GBIC transceiver can be installed in either slot.
Figure 21. Installing a GBIC Transceiver
3. Repeat this procedure to install another GBIC transceiver or go to
"Cabling the Switch" on page 53.
For GBIC optical and cabling specifications, consult the documentation
shipped with the module.
To install an SFP transceiver in an AT-9408LC/SP, AT-9424T/SP,
AT-9424Ts, AT-9424Ts/XP or AT-9448T/SP switch, perform the following
procedure:
1. Remove the dust plug from the transceiver slot where the SFP
transceiver is to be installed, as shown in Figure 22.
Figure 22. Removing a Dust Plug for an SFP Slot
2. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
3. Position the transceiver with the label on top.
AT-9400 Series Layer 2+ Gigabit Ethernet Switches Installation Guide
2 3 R
C L A
L A S S S 1
E R P
G B I C R O D
U C T
2 4 R
2 3
G B I C
L /A
1 0 0 0
L IN K
P O
D /C
/
F D X
A C T
1
L /A
3
5
7
D /C
2 4
L /A
D /C
2
4
6
8
49