Installing The Switch In A Rack - Allied Telesis AT-9408LC/SP Installation Manual

Chapter 2: Installation

Installing the Switch in a Rack

46
Perform the following procedure to install the switch in a standard 19-inch
rack:
1. Place the unit upside down on a level, secure surface.
2. Using a flat-head screwdriver, remove the snap-on plastic feet from
the bottom of the switch, as shown in Figure 18.
3. Turn the switch over.
4. Attach a rack-mount bracket to one side of the switch using four of the
screws that came with the switch, as shown in Figure 19.
Figure 19. Attaching Rack-Mount Brackets
5. Install the second rack-mount bracket on the other side of the switch
using the four remaining screws.
Figure 18. Removing the Feet