Table of Contents
Advertisement
6. Source Connections
Blue in Green Switch in the ON position
Blue in Green Switch in the OFF position
Table 6-4
Blue in Green Switch
Leaving the switch in the ON position will result in abnormal color balance of the projected image.
Force Negative Sync Switch
Force Negative Sync Switch in the ON position
Force Negative Sync Switch in the OFF position
6.3 RGB Analog Source with Composite Sync to Port 4/5
Which signal to Port 4/5?
RGB analog input terminals with separate H and V sync inputs, composite sync input or with sync on green (BNC terminals). The
projector detects automatically where the sync signal is located.
Always use an interface (e.g. Barco Magik Interface R9828120) when a computer and local monitor have to be
connected to the projector as the signal cable coming from the computer is limited to 60 cm due to interfer-
ences.
The RGB analog input accepts only sources with a horizontal frequency of 32 kHz and higher. To connect a
source lower than 32 kHz, an Optional Decoder + Limo Pro (R9828631) has to be installed.
Image 6-10
Port 4/5
RGB Analog Video with Composite Sync Input Selection
1. Press digit button 4 or 5 on the RCU.
Button 4 on the RCU
Button 5 on the RCU
Table 6-6
Port 4/5
6.4 Component Video Source to Port 4/5
Which signal to Port 4/5?
R-Y)Y(B-Y) analog input terminals with sync input or with sync on the luminance (Y) input (BNC terminals). The projector detects
automatically where the sync signal is located.
32
Computer
to computer
to monitor
Blue in Green Active
Blue in Green Disabled
The Sync Pulses must be Negative
The Sync Polarity will be Automatically Detected
Magik Interface
(R9828120)
Sync. on Green
Separate Sync.
R5976257 BARCO REALITY 909 15/03/2003
Port on projector
R
G
B
Comp / H-Sync
V-Sync
PORT 4 / 5
Advertisement
Table of Contents
