Mendota DXV-45 DT3-LX Operating Instructions Manual page 46

5. Using a ½" deep well socket wrench, remove Front and Rear Orifices.
HINT: PACK SOME SOFT PAPER OR INSWOOL INSIDE DEEP WELL SOCKET TO STOP CAP ORIFICE FROM
SLIDING TOO FAR INTO THE SOCKET.
6. Thread a new 3/64" drilled orifice to the Front Orifice mounting brass fitting and new #53 drilled orifice to the Rear Ori-
fice mounting brass fitting. Tighten down orifices.
7. Locate Pilot Light on left side of firebox. While holding the pilot base body with large vice grips tightly, loosen Pilot
Light's hex shape base using a ½" open end wrench. Rotate counter clock-wise ¼ turn to loosen.
8. Pilot arrives from the factory set for NG. Push NG/LP Adjustment Clip inward all the way to set it for LP. See detail
view, below. If you see "NAT" printing on the Adjustment Clip, this indicates that the pilot is set to burn NG. Push Clip
in so that "NAT" is not visible.
9. Tighten down Hex shaped base of pilot using a ½" open end wrench.
45