Completed Logs And Coal Bed Assembly Evaluation - Mendota DXV-45 DT3-LX Operating Instructions Manual

FINAL LOG SET, COALS AND INSWOOL LAYOUT RECOMMENDED PATTERN
Note: Some minor adjustment to coals locations may me necessary on LP gas units. Also, some
adjustment to brushed inswool thickness may be necessary if inswool brushed over middle or
rear burner are too thick and heavy and impede combustion air flow to burner.

COMPLETED LOGS AND COAL BED ASSEMBLY EVALUATION

See the picture, shown above. This picture shows the recommended log positions. Slight variations
in the position of each log is allowed. However, if any log position is significantly out of position in
comparison to the diagram above and if any flames are floating off the burner surface (Ghosting) after
10 minutes of starting the fireplace, turn off the fireplace and contact your installer or fireplace dealer.
Have the Installer/Dealer adjust the log positions of the logs and coals and also conduct a thorough
evaluation of the venting configuration to make certain that the venting configuration conforms to
Mendota's venting requirements, which are listed in this Installation and Operations Manual.
31