Network Settings; What Can Be Done - Barco SIM 7Q HB User Manual

Sim 7q series
Hide thumbs Also See for SIM 7Q HB:
Table of Contents

Advertisement

4.7.3.2

Network settings

C
AUTION
In normal conditions, the network detection takes few seconds. This means that the total time needed to go
from power ON to Standby mode is only a few seconds. This value can vary depending on the speed of the
network connection.
But when the DHCP setting of the projector is set to Yes and the network does not allow the projector to obtain
an IP address from the DHCP server, the startup time will be delayed by upto five minutes. After this time, a
time-out occurs if the network detection fails, and the projector starts up without any network connection.

What can be done?

These settings are used to set the Ethernet Communication parameters.
Following parameters are available :
MAC Address
IP Address (Current)
Subnet Mask
Gateway
DHCP
IP Address
Subnet Mask
Gateway
Hostname
How to set up the network settings ?
1. Press the MENU key to activate the Menu bar.
2. Push the cursor key ← or → to highlight Installation in the menu bar.
3. Push the ↓ key to pull down the Installation menu.
4. Push the cursor key ↑ or ↓ to highlight Network settings and press ENTER to select.
Image 4-38
R59770066 SIM 7Q SERIES 07/10/2013
:
Make sure that a DHCP server is available in the network and works fine.
MAC Address of the projector (This is a non-adjustable value programmed into the Ethernet
board).
IP Address of the projector (This is a non-adjustable value).
Subnet Mask (This is a non-adjustable value)
Gateway (This is a non-adjustable value)
DHCP setting:
Yes: The projector will dynamically obtain its IP address from the DHCP server.
No: The IP address needs to be entered manually. Note that when selecting Fixed IP
the IP settings fields are enabled
Fixed IP Address of the projector : this field can be edited when Fixed IP is selected
Subnet Mask : this field can be edited when Fixed IP is selected
Gateway : this field can be edited when Fixed IP is selected
Hostname : this field can be edited when DHCP is selected
4. Installation
45

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents