Basic Troubleshooting Guide - Barco SIM 7Q HB User Manual

9.2

Basic troubleshooting guide

About this chapter
In this section we start from the symptoms that can be seen in case of an unusual situation to come to a possible cause and solution
or to detect which module is causing the problem. It is a first level tool which implies that it will not be possible to come to a solution
at all times. If no solution can be found by using this troubleshooting guide, please contact your dealer.
NO POWER
SIM 7Q(P):
troubleshooting
NO CONTROL
Image 9-2
R59770066 SIM 7Q SERIES 07/10/2013
POWER CORD NOT HOT
POWER CORD NOT PLUGGED
MAINS SWITCH OFF
TEMPERATURE OUT OF RANGE
BACK TO STANDBY
HUMIDITY OUT OF RANGE
VERY HIGH ALTITUDE
LAMP
NO SOURCE SELECTED
LAMP ON
NO SOURCE SIGNAL FOUND
NO IMAGE
PROJECTOR IN STANDBY
LAMP OFF
Replace lamp
STRETCHED / SHRUNK IMAGE
WRONG ORIENTATION
ARTEFACTS
FLICKERING IMAGE
NOICE
BAD ZOOM
BAD FOCUS
BAD SOFT EDGE
POOR IMAGE
BAD BRIGHTNESS or
CONTRAST
NO RCU CONTROL
Check external power supply
Replace the power cord
Plug in power cord
Switch ON
INTERNAL TEMP.
EXTERNAL TEMP.
Decrease humidity in the room
Replace lamp
Select a source
NOT CONNECTED
Check wires and connectors
Check IG
Switch to active state
Adjust the Scaling setting
Adjust the Orientation setting
Replace lamp
Check the optical cables and Tx, Rx
Check the IG
Check cabling and connections
Adjust lens zoom
Adjust the lens focus
ELECTRONIC SOFT EDGE
Adjust the dimmer settings
Clean the projection lens
Adjust brightness/contrast
Remove blocking objects
Program the correct address
Insert new batteries
9. Troubleshooting
Clean/replace air filter
Cool down the room
Connect the source
Switch on soft edge
Time Of Day
CLO
255